A boiler is called a high-pressure boiler when it operates with a steam pressure above 80 bars. The high-pressure boilers are widely used for power generation in thermal power plants. In a high-pressure boiler, if the feed-water pressure increases, the saturation temperature of water rises and the latent heat of vaporization decreases.

There are a number of considerations to factor when determining the best boiler for your steam generation needs like operating pressure, steam pounds/hour output, demand fluctuation, general application requirments and total cost of ownership, etc. Two primary boiler types, the firetube boiler and the watertube boiler, are essentially opposite in design. The firetube boiler passes combustion

10. Advantages of water tube boiler:- 1) Larger heating surface can be achieved by using more numbers of water tubes. 2) Due to convectional flow, movement of water is much faster than that of fire tube boiler; hence rate of heat transfer is high which results into higher efficiency.

The difference between fire tube boiler and water tube boiler can be done on various points. These points includes types of fluid flows within the tubes, steam generation rate, floor area required for the steam generation, transportation, efficiency, fluctuating loads, operating cost etc. the knowledge of the difference about these two boiler is very crucial.

In Lees' Loss Prevention in the Process Industries (Fourth Edition), 2012. 12.8.4 Waste Heat Boilers. Process heat recovery boilers, or waste heat boilers, are widely used, particularly on ethylene and ammonia plants and on sulfuric acid and nitric acid plants.This type of boiler has developed as a cross between a conventional shell-and-tube heat exchanger and a firetube boiler.

: Ahmed Rahmani: 296KBWater is inside the tubes of a water tube boiler and outside the tubes of a fire tube boiler. What is the purpose of the zinc rod used in steel boilers? It prevents corrosion by reacting with corrosive elements before they attack the boiler.

Comparison between Fire Tube and Water Tube Boiler can be done in 14 aspects. Those aspects are operating pressure, passage of material type in tubes, rate of steam generation, handling of load fluctuation, floor area requirement, efficiency, operator skills, design, maintenance cost are listed below in …

2004-3-19 · Fire-Tube Boiler (~1800) The fire tube boiler, the oldest design, is made so the products of combustion pass through tubes surrounded by water in a shell. The furnace/flame volume can either be inside or external to the shell that contains the water. The upper steam capacity of fire tube boilers is about 20,000 Ibm/hr, and the peak pressure